165cm Realistic Japanese Sex Doll - Breanna Item NO.: SD208501

AXB DOLL Operating and maintenance instruction

1. Exterior layer is made of high standard elastic properties TPE (Thermoplastic elastomers) coupling with epoxy resin firm body support and finely crafted skeleton. All materials complied with National Health & Safety Standard which is harmless to human and is environmental friendly.

2. This finely crafted skeleton & joints allow model to post with various stunning position and style within stipulated level. With artistically mind, she can be very human. For durability, do not position at highly stretch style over long period of time. Although elasticity of TPE material is marvelous, excessive stretch for long period might result in deformation. Please reposition model to its original position, with hand rested downwards, after used.

3. This is a standard procedure during manufacturing to mount and position its skeleton at precise points. Various supporting were attached during injection process.Thus, there will be some small fillings to these holes which is not classified as manufacturing defects

4. Avoid sharp objects or kneading with excessive strength.

5. Strongly advice to test colors fading of dresses prior wearing onto model. Should particular dresses have sign of fading, please do not wear onto model as stain could hardly be removed. We shall not be responsible for its consequences.

6. Do not exposed model under sunlight for long period of time. This might increase aging of TPE material and life spends of the model.

7. Should creasing or pressure mark occurs, may apply warm towel to creased area.

8. Dust and dirt may be cleaned with normal washing detergent, dish washer or foam bath. Clean gently with palm and beware of finger nails and coarse materials which might affect or scratch its surface. When dried, apply with powder provided or corn starch powder. Model will be as good as new again. We strongly recommend periodical maintenance of your model.

9. Should model?s surface experienced scratch, cut or poke, please use supplied TPE glue to seal. Clean defected area with makeup remover before gluing. Make sure defected surface is not in tension when applying TPE glue. Curing time is approximately half an hour.

Should you have any other doubts in technical aspects or maintaining the model, please do not hesitate to contact vendor for further assistance.